Viking Repair Redmond, WA (425) 905-2822

Redmond, WA · Viking

Dishwasher Repair

Drain, wash-arm, heater and door-latch repair for Viking panel-ready and integrated dishwashers.

Dishwasher drawn right out of its cabinet on the floor, motor, pump and hoses visible under the insulated tub

What we get called out for

  • Standing water left in the sump at the end of every cycle
  • Dishes come out gritty with detergent still in the dispenser
  • Door latch will not catch so the cycle never starts
  • Cycle runs for hours and the dishes are still cold and wet

What the reading usually says

  • Standing water in the sump every cycle

    ReadingDrain not clearing

    Drain pump impeller jammed, check valve stuck, or the air gap at the sink blocked. Three cheap causes before anything expensive.

  • Dishes gritty, detergent still in the cup

    ReadingNo wash pressure

    The wash arms are not turning — a clogged filter starving the circulation pump, or a split spray arm bearing. Detergent left behind proves it.

Before you call

Have the model and serial number ready — on Viking equipment they are on a plate behind the door, under the control panel or along the inside of the cabinet frame. With the model in hand we can usually tell you on the phone whether the likely part is on the van or has to be ordered, which decides whether this is a one-visit job.

It also helps to know how long the symptom has been building. A fault that appeared overnight and one that has been creeping for a month rarely have the same cause, even when they look identical from the front.

Reviews · Redmond

What Redmond customers report back

  1. Machine kept stopping partway through with a blinking light. It was a kinked drain hose behind the cabinet, left that way at install. He rerouted it and the cycle finishes every time now.

    Ulla G.Downtown Redmond

  2. Standing water left in the bottom after every single cycle. The drain pump impeller had a shard of glass wedged against it. Out in ten minutes, and he checked the air gap at the sink while he was there.

    Dara M.Redmond Ridge

  3. Door latch stopped catching so the cycle never began. He replaced the latch switch and adjusted the custom panel, which had drifted out of square. No more slamming the thing twice.

    Quinn A.Overlake

Next step

Tell us the model and what it is doing

Two minutes on the phone usually narrows a Viking fault to one or two parts before anyone is dispatched to Redmond. No charge for the conversation — the $89 service call starts when a technician is at your door, and comes off the bill if you approve the repair.

(425) 905-2822 Book online

On site 8:00 am – 8:00 pm, seven days · phone answered 24/7